




Yes. Fans from the Vents Casto One EC series are designed for installation in Zone 1 - directly above a bathtub or shower tray, where water splashes can reach the casing. This lets you place the fan in the wettest part of the bathroom, where it clears steam and condensation fastest. The only requirement is that the wiring follows the diagram in the user manual and the electrical safety rules for wet rooms. This work is best left to an electrician.
All models in the series share the same motor, the same 95 m³/h air flow and the same 26 dBA noise level, so the choice comes down to how you prefer to control the fan. The basic Vents 100 Casto One EC is switched with a regular wall switch, while the V version has a pull cord on the casing. The T model has a turn-off timer: after you switch the light off, the fan keeps running for a few more minutes to finish ventilating the room. The T1 model has a turn-on delay timer, so the fan does not start every time someone pops into the bathroom for a minute. For a bathroom where the air is constantly humid, the most practical option is the TH model with a humidity sensor and timer. The fan switches itself on when humidity rises above the set level and switches off once the air is dry again. No input from you is needed.
For a typical bathroom in an apartment, it is more than enough. The required air exchange rate for bathrooms is set by the building regulations of your country, so check the local requirements first. As a manufacturer, we can say that the 95 m³/h delivered by the Vents 100 Casto One EC covers a standard bathroom or toilet with a wide margin and quickly removes steam after a shower. The fan connects to a standard ventilation shaft or a 100 mm (4-inch) air duct. If the shaft is some distance away, a flexible duct can be used - a run of that length will not noticeably affect performance.
Two reasons. The first is the mixed-flow impeller: its aerodynamic shape moves the same volume of air at a lower speed, and lower speed means less noise. The second is the EC motor on ball bearings, which draws only 3 W and runs without the hum typical of older motors. As a result, the sound pressure level at 3 m is 26 dBA. For comparison, that is quieter than a whisper, and the fan is completely inaudible from the next room.
| Lineup Vents Casto One EC | Connected air duct size, mm | Rated power, W | Maximum airflow, m³/h | Sound pressure level LpA at 3 m, dB(A) | Pull cord | Humidity sensor | Timer |
|---|---|---|---|---|---|---|---|
| 100 | 3 | 95 | 26 |
|
|
|
|
| 100 | 3 | 95 | 26 |
|
|
|
|
| 100 | 3 | 95 | 26 |
|
|
Turn off timer | |
| 100 | 3 | 95 | 26 |
|
|
Turn on timer | |
| 100 | 3 | 95 | 26 |
|
|
Turn off timer |