Privacy Policy (GDPR)
Not registered yet? Take advantages of registration:
Products saving in a binding to the projects
Product consultation from our experts - Online
By using this form, you confirm that you have read the site terms of use Terms of use and completely accept the terms of use

VENTS Outer ventilation hood MVVM 162

  • Description
  • Modifications
  • Downloads
  • Video
  • The outer hood is designed to prevent ingress of water and large objects into the ventilation equipment from outside.
  • Pre-installed with a hood the air duct is mounted in a core hole drilled in the wall. The installation is done from inside.
  • Special design allows installation of the hood by the operator on a wall of high-rise buildings and enables airtight sealing of the air duct in the core hole.



  • Made of high-quality incombustible ultraviolet resistant plastic.
  • Fixation at the end of the air duct with latches.
  • The air duct with diameter of 160 mm is made of high-quality PVC plastic.
  • The ventilation hood [1] is equipped with a silicone sealing ring [2] that provides high sealing integrity of the air duct [3] in the core hole in the wall.
  • Drill a core hole with a diameter of 180 mm in the wall.
  • Insert the hood into the wall core hole and push it until the sealing ring appears on the outer side.
  • Pull the hood in the opposite direction so the silicone sealing ring provides tight seal between the hood and the wall.
  • The air duct must be fixed in the wall core hole using mounting foam.
Brochure "MVVM 162" (pdf 670.73Kb)
Download high quality image "MVVM 162" (psd 1.71Mb)
Download image "MVVM 162" for your website (png 344.11Kb)

Share your opinion
I found this page useful to select the required products easy and quick
No difficulties with the site use. Everything is logical ad clear
The site produced a nice impression

Basic parameter for domestic fan selection