VENTS VUTR 2000 WH EC

• The air handling units VUTR WH EC with a water heater are the fully-featured ventilation units that ensure air filtration, fresh air supply and stale air extract.

• During the operation process the extract air heat is transferred to the supply air through the rotary heat exchanger.

• The units are used in ventilation and air conditioning systems installed in various premises that require reasonable energy saving solutions and controllable ventilation systems.

• EC motors reduce energy demand by 1.5-3 times and ensure high performance and low noise operation. 

• The VUTR 400/700/900/1200/1500 WH EC units are compatible with round air ducts (Ø 160, 250 and 315 mm).

• The VUTR 2000 WH EC units are compatible with rectangular air ducts (Ø 500x300).

• The casing consists of a frame and three-layer 20 mm (VUTR 1500 and 2000 – 25 mm) thick panels made of zinc aluminium internally filled with mineral wool for reliable heat- and sound-insulation.

• Due to the specially designed removable side panels the unit requires little space for servicing and accessing to all the unit components.

• The two integrated G4 filters ensure sufficient supply and extract air purification.

• The air handling units are equipped with high-efficiency electronically commutated (EC) direct current motors with an external rotor and backward-curved blades.

• These state-of-the-art motors offer the very best in energy efficiency today.

• In addition to that, EC motors combine high performance and optimum control over the entire speed range.

• The high efficiency (up to 90 %) is a definite advantage of EC motors.

• The rotary heat exchanger is a short rotating cylinder filled with layers of corrugated aluminium tape packaged in a such way so as to enable free passage of the supply and extract air flows.

• As the cylinder rotates the aluminium tape contained in the heat exchanger is first exposed to the supply air stream and then - to the extract air stream.

• As a result the material undergoes repeated warming and heating cycles thereby transferring heat and humidity from the warm air stream to the cold one.

• Compared to plate-type devices a rotary heat exchanger demonstrates better efficiency and helps maintain a comfortable air humidity level while reducing frostbite danger to a bare minimum (tending to zero at normal temperature and humidity).

• The air handling units are equipped with water heaters to operate at low outside temperatures.

• If heat recovery is not sufficient to reach the set supply air temperature, the heater is activated to warm up supply air.

• The heaters are equipped with protecting devices to ensure safe and reliable operation of the unit.

• The water heaters are designed for maximum operating pressure 1.0 MPa (10 bar) and maximum heat medium operating temperature +95 °C.

• The VUTR WH EC A17 units are equipped with a th-Tune control panel.

• The VUTR WH EC A18 units are equipped with a pGD1 control panel.

• Speed selection: low, medium, high.
• Speed is individually adjusted from 0 to 100 % for the supply and the extract fans.
• Filter maintenance indication.
• Alarm indication.
• Timer-based operation.

• Week-scheduled operation.
• Supply air temperature control.
• CCU control.
• Air damper actuator controlling.

• The unit is designed for mounting to a horizontal plane, suspension to a ceiling or wall mounting by means of brackets.

• Service access is from the left side panel (in air direction).
• The water heater pipes on the VUTR WH EC unit are leaded to the service side, on the left (in air direction).

t = t_outd + k_hr * (t_ext - t_outd) / 100, 

where

t_outd – outdoor air temperature [°C],

t_ext – extract air temperature [°C],

k_hr – heat exchanger efficiency 

(according to the diagram) [%]