VENTS VUE P3 air handling units with heat recovery

Description

APPLICATION
The VUE P3 air-handling units are the fully featured ventilation units with heat recovery for air filtration, fresh air supply and stale air extract. The heat contained in the extract air is recuperated in the heat exchanger to warm up supply air.	Designed for application in various ventilation systems that require cost-saving and controllable ventilation.
FANS	DESIGN
Single-phase external rotor motors with radial impellers and forward curved blades. The motors have overheating protection with automatic restart.	The casing is made of polymer coated steel panels, internally lined with 5 or 10 mm heat- and sound-insulating layer of cellular polyurethane, depending on modification.
HEAT RECOVERY
Plate enthalpy cross-flow heat exchanger made of polymerized cellulose with recovery efficiency to 87 %. The enthalpy heat exchanger enables not only heat, but also humidity recovery, thus maintaining stable indoor humidity. In the summer period the intake air is cooled down in the heat exchanger and dehumidified and in the winter period it is warmed up and humidified. Water vapour from the humid extract air is condensed and absorbed by the heat exchanger plates. The recovered humidity and heat are transferred to the supply air flow. The air streams are fully separated within the heat exchanger and the microbes and smells are isolated.
AIR FILTRATION	CONTROL AND AUTOMATION
Efficient supply air filtration with two built-in G4 and F8 panel filters. Extract air filtration with a panel G4 filter.	The VUT/VUE P3 A1 unit is equipped with the speed controller RS-1-400. The VUT/VUE P3 A12 unit has the speed controller with touch buttons and LED indication SRS-1. The service side of the unit has a removable inspection door with hand screws for cleaning or replacement of the filters and the heat exchanger. The control unit is located inside of the unit casing. The power cable and the ground cable are connected to the control unit via the cable glands on the unit side wall.
FREEZE PROTECTION	MOUNTING
The heat exchanger freeze protection operates as follows: in case of freezing danger determined by the temperature sensor the supply fan is turned off to let extract air warm up the heat exchanger.	Due to low height of the casing the unit offers the optimum solution for the suspended ceiling installation in limited installation space. The installation place must provide sufficient service access to the unit.
APPLICATION

Series	Rated air flow [m³/h]	Design features	Casing modification	Control panel
VENTS VUE: energy recovery ventilation	150, 250, 350	P: suspended mounting	3: low-profile unit	А1: speed switch RS-1-400 А12: sensor speed control panel SRS-1

Model	G4 panel filter	F8 panel filter
Model
VUE 150 P3	SF 300х220х48 G4	SF 300х220х48 F8
VUE 250 P3	SF 300х220х48 G4	SF 300х220х48 F8
VUE 350 P3	SF 300х270х48 G4	SF 300х270х48 F8